ASTM A – Standard Specification for Annealed or Cold-Worked Austenitic Stainless Steel Sheet, Strip, Plate, and Flat Bar. This standard is a part of ASTM. ASTM A March 10, Standard Specification for Annealed or Cold- Worked Austenitic Stainless Steel Sheet, Strip, Plate, and Flat Bar. This specification. ASTM A – Designation: A – 10 Standard Speci?cation for Annealed or Cold-Worked Austenitic.
|Published (Last):||13 March 2014|
|PDF File Size:||18.82 Mb|
|ePub File Size:||20.84 Mb|
|Price:||Free* [*Free Regsitration Required]|
These alloys represent an excellent combination of corrosion resistance and fabricability. Specimens shall astj bent around a diameter equal to the product of the bend factor times the speci? A — 10 Standard Speci? Chemical equipment and piping, heat exchanger components, dairy and food handling equipment and utensils, cryogenic vessels and components, architectural and structural applications exposed to non-marine atmospheres Chemical Composition: HRC typical L Ann 25 min.
Hard Elongation in 2 in.
If filler metal is required, Type is normally used. Last previous edition approved in as A — Maximum unless otherwise indicated. The noncontrolling factor normally will exceed considerably the speci?
and L Stainless Steel – NKS
Chemical equipment and piping, heat exchanger components, dairy and food handling equipment and utensils, cryogenic vessels and components, architectural and structural applications exposed to non-marine atmospheres.
Permission rights to photocopy the standard may also be secured from the ASTM website www. Only annealed conditions of ashm speci?
Originally approved in Due to the high work hardening rate of these materials, intermediate anneals maybe required to successfully fabricate the part. The choice of test method for materials in conditions other than annealed shall be at the option of the seller.
Types and L cannot be hardened by thermal treatment. Find out what NKS can do for you.
However, in the case of dispute, tests shall be made by pressure. One bend test shall be made from one end of each coil. Your comments are invited either for revision of this standard or for additional standards and should be addressed to ASTM International Headquarters. Material Test Report and Certi?
Your comments will receive careful consideration at a meeting of the responsible technical committee, which you may attend.
Type L Stainless Steel is asttm in welding applications to exclude the formation of chromium carbides during cooling in the heat affected region of the weld. This standard is subject to revision at any time by the responsible technical committee and must be reviewed every?
ASTM A for Annealed or Cold-Worked Austenitic Stainless Steel Sheet, Strip, Plate, and Flat Bar
A number in parentheses indicates the year of last reapproval. C Annealed material that naturally meets mechanical properties may be applied.
Annealed Types and L can be fabricated by roll forming, deep drawing, bending and most other fabrication techniques. Types and L provides xstm resistance in a wide range of moderately oxidizing and reducing conditions, fresh water and non-marine applications. Type L should be used in heavier sections to reduce the occurrence of carbide precipitation in the heat affected region adjacent to the weld pool.
ASTM A666 for Annealed or Cold-Worked Austenitic Stainless Steel Sheet, Strip, Plate, and Flat Bar
Users of this standard are expressly advised that determination of the validity of any such patent rights, and the risk of infringement of such rights, are entirely their own responsibility.
Type L LN The values given in parentheses are for information only. If you feel that your comments have not received a awtm hearing you should make your views known to the ASTM Committee on Standards, at the address shown below. Depending on the work hardening characteristics of the particular grade, either the yield or the tensile strength can be the controlling factor in meeting the properties.
Rockwell B 95 95